|
|
| Body with angular profile, merging with rim which slopes upward toward central opening. Broad nozzle unbridged; straight sided with rounded end. No base.
Hard black glaze inside and around edge of opening ... 15 June 1931 |
| On rim, groove with red miltos, slopes to the center.
Handle broken, with horizontal band.
High base, red bottom. Broken, long deep nozzle.
Hard black glaze.
Pale red Attic clay.
Type VIIA (glazed variety) ... 16 June 1931 |
| Broad, flat rim, sloping to center.
Horizontal, broad handle broken. Long, deep nozzle, with small wick hole.
Fairly high base; unglazed.
Hard black glaze.
Pale red Attic clay.
Type VI (late 5th. century ... 16 June 1931 |
Rim decorated with small raised dots.
Double convex body with rounding profile, covered with raised dots. Small concave discus surrounded by two raised lines; central filling hole.
High vertical handle, ... 16 June 1931 |
| Nozzle broken.
Profile with addiotional grooves. Rim grooved, with sunken area around central filling hole. No handle. Nozzle deep and broad. High base.
Unglazed.
Pinkish-buff clay.
Type VIIB of Corinth ... 18 June 1931 |
Body with curving sides merging with rim; open socket through center.
Short nozzle, blunt nozzle encroaching on rim. High base.
Mottled red and black glaze over the entire lamp, badly chipped.
Buff clay ... 28 June 1931 |
| On rim, raised ovules around small flat top.
Double convex body; vertical handle; end of nozzle broken.
Fairly high base, inscribed: "IAΦH".
Glaze black metallic, with silvery sheen.
Pale red clay.
Type ... 3 July 1931 |
| Lamp is attached to a high standard of which the front is in the form of a column.
From the ridged necking spring two volutes; between them are raised loops, and below, above the necking, a band of raised ... 25 July 1931 |
| Nozzle broken.
Concave top. Angular profile, sides converging toward top; on the left side a pointed knob, unpierced.
Vertical band handle, broken away.
No base. Bottom, untrimmed; glazed.
Thin black metallic ... 13 July 1931 |
Flat rim, sunken 0.008m. below top of body.
Double convex body, with large pierced knob on the left side.
Round nozzle; end broken. No handle.
No base; the flattened surface becomes slightly concave toward ... 13 July 1931 |
End of nozzle missing.
High curving body. Very slightly sloping rim; ornamented with two deep grooves.
Nozzle deep, flat on top. High base, slightly concave.
No handle; but on the left side is a small ... 21 July 1931 |
Miniature lamp.
Rim merges with the body; at the inner edge, a groove, and a small ridge round the central opening.
Sides curving outwrad toward junction with rim. Irregular nozzle, spoon-shaped; rather ... 22 July 1931 |
Front part of lamp.
Rim merging with sides; broken along inner edge; close to the break, traces of a reserved band.
Short nozzle, shallow, rounded, encroaching on rim. No base; under surface slightly concave ... 10 August 1931 |
Fragment of rim and side.
On nozzle, remains of a wick hole encroaching upon the rim.
Flat rim, sloping slightly toward large opening, and projecting a very little on the exterior, over the slightly curving ... 1931 |
Nozzle and front of infundibulum preserved.
On rim, single rill, concave curve toward filling hole.
Nozzle short and flat.
Good black glaze inside and outside.
Fine red clay.
Type V (second variety) of ... 16 July 1931 |
Nozzle and front half of infundibulum preserved.
On rim, single groove around filling hole. Mold made.
Traces of knob of left side of body.
Nozzle long, rounded at tip, line of attachment to body on either ... 1931 |
| Nozzle and fragment of rim preserved.
Rim, carried up as a high ridge surrounding the filling hole, around this ridge is a double row of triangles in low moulded relief.
Long, pointed nozzle, flat on top ... 6 July 1931 |
|
|
